Application Areas of Over Band Magnetic Separator
Five type of Separators Re designed to operate at a predetermined working gap over the conveyor : 100, 150, 200, 250 and 300mm.
The speed of the belt , the nature of the product, its density, its granulometry and the size of the pieces which have to be extracted are on of the parameters to be taken into consideration when choosing the type of Over band.
Construction of this Magnetic Separator:
Two U-section pieces are fixed on the Magnet by Fastening ears and are supporting bearings of Drums. Drums are equipped with shafts mounted on removable hubs. All bearings equipped with stakes for tightening the belt.
The belt is driven by a Reduction Gear Coupled to Electric Motor / Geared Motor by Vee- belts
The Magnet is made of High Intensity Strontium Ferrite Magnets and is guaranteed for the Magnetic Power through out the life of installation. A Non - Magnetic Stainless steel Plate is provided to cover the poles of Magnet. There is no need for any electrical supply or maintenance
Installation of our Over Band Magnetic Separator is so easy.
These units can be installed either inline over the terminal head pulley (Fig - 1. ), or transversal to the conveyor (Fig - 2). In both cases, it is necessary to foresee Non- Magnetic products under the Magnetic Field.
The most effective position is inline (Fig - 1) over the head pulley. The material being conveyed is in virtual Suspension and Tramp Iron is therefore more readily extracted.
Very good results are obtained by combining a Permanent Magnetic Over band with Permanent Magnetic Pulley at discharge end.